Extruded Magnesium Anode Rods
To suit domestic and commercial hot water heaters, cooling towers and in-ground installations.
Available in high (M1) and low (M2) potential alloy, in lengths up to 3 metres - assembled and blank form.
|
Each anode has a 3 mm diameter steel core running lengthwise through its centre. Assemblies are available in various configurations. 1. Both ends plain (saw cut). 2. One end plain, one end threaded. 3. One end plain, one end capped. 4. One end plain, one end with core wire exposed. 5. Core wires exposed both ends. 6. Flexi type anode - one end welded with steel cap with short anode segments on a solid flexible steel core. (M2 21 mm Ø ONLY)
1 2 3 4 5 6 |
Anode assemblies are available with a standard 3/4" B.S.P.T. Steel Cap for the 21 mm diameter rod and a 1" B.S.P.T. steel cap for the 27 mm diameter rod.
These anodes are colour coded
to identify the material type for a given water quality.
Water quality is defined by the Total Dissolved Solid (TDS) content.
The table below shows the correct anode type for a given water quality.
| Cap Colour Code Green Orange or Black Blue |
Material / Potential Magnesium High Potential AS2239-M1 Magnesium Low Potential AS2239-M2 Aluminium AS2239-A5 |
Total Dissolved Solid (TDS)
Content 0 - 40 mg/L 40 - 600 mg/L 600 - 2500 mg/L |
|
Blank Lengths are available in the following sizes. Low Potential (M2) Diameter mm Length mm 21 Nominal Up to
3000 High Potential (M1) Diameter mm Length mm 21 Nominal Up to
3000 |
CATHODIC DIECASTING QLD PTY.LTD
| 8 Endeavour Drive | Phone: (07) 5476 9788 | International Phone: 617 5476 9788 |
| Kunda Park | Fax: (07) 5476 8268 | International Fax: 617 5476 8268 |
| Queensland 4558 | ||
| Australia | ||
| email:cathodicdiecasting@bigpond.com |
